Some designs come out of the mold without a cut; with others, a single cut makes the candle much easier to remove. If you cut, always do it while the mold is empty, before the first pour.
Our Taper Candle Molds M1–M11 and our Ghost Taper Candle Mold are shipped with a cut; don’t cut them, go to step 5. All our other molds arrive uncut. Not every mold needs cutting; it depends on the design and how you use it.
Cut on the back or side of the design, through a thick area. This keeps the front of the candle clean.
With a craft knife or scalpel, start at the pouring opening and follow the lines of the design. A straight cut usually works best.
Craft knifeGently part the cut and check that it reaches the inside of the mold. Then line the edges up exactly.
Before pouring, wrap the mold with rubber bands or packing tape along the whole cut. Material leaks out of a cut that is not closed tightly.
Once the candle has cooled completely, remove the bands or tape, open the cut and peel the mold off the candle.
Place the mold on a flat surface while cutting and always draw the blade away from you.
Yes. Our Taper Candle Molds M1–M11 and our Ghost Taper Candle Mold are shipped with a cut so the candle comes out easily. Before pouring, wrap the mold with rubber bands or tape.
No. Many designs come out without a cut. If you decide to cut, do it before the first pour.
Not if the mold is wrapped all the way round with rubber bands or tape.
A thin line may remain where the cut is. That is why we cut on the back or side, never on the front.